null
Was: £153.99
Now: £92.40

Wood Side Panel Tilt Stand - Native Instruments NI Maschine MK3

SKU:
WP-NIMMK3
UPC:
WP-NIMMK3
Condition:
New
Availability:
Currently Out of stock - No EXACT ETA

NI Maschine MK3 Tilt Real Walnut Tilt Stand

Native Instruments Maschine MKIII the classic look with these wood side panels with tilt setup made from real walnut. Walnut is the same wood used in hight end Bentley and Rolls Royce dashboards!

Description:

Complete 2 piece real walnut NI Maschine MK3 wood panel kit along with 2 support dowels and rubber feet for traction on slick areas. This kit installs very easily and can be taken on and off very quickly These also have holes where you can install (not included) screws if you want to make them more permanently secure rather than being able to remove easily for transport. The tilt angle is approximately 15 degrees.

Included Parts: (ASSYs)

  • Left Side Panel (Walnut)
  • Right Side Panel (Walnut)
  • 2 - Support Dowels (not coated or finished, but can be easily painted - these dowels are under the unit and not really seen)

This Part will fit:

Native Instruments Maschine MK3

Please Note:

These wooden parts may have slight variations in color and due to the type of Walnut wood that is used some sides can look a bit different than each other. Being that they are wood, you must be careful to treat them properly. Please watch the install video shown below to insure that you are installing the panels properly. Since the panels are wood you may see the slight variations and small flaws in the wood. If you have any questions about this please email us. Does not include white skin that is pictured.

Installation Guides / Videos: